|
SC-7025 Mercedes SLS AMG GT3 #739
We've taken an 8000RTR chassis and a 7025b body kit and made an Ready To Run car of the two.
We leave it to you to install the rearview mirrors knowing that many would rather they not be installed.
Ball bearings at all four corners.
M3 setscrews for the wheels and spur gear.
SC-0025 'Sprinter' motor.21,000 rpm and 320g/cm torque at 12 volts.
Gearing is 12x44
Stock Guide is SC-1601
Supplied with rubber tires suited to NINCO Track, for better performance on Carrera and wood the SC-2421 Pro Comp 3, SC-2621 Pro Comp 2 or SC-2121 Pro Comp tires are recommended. Pro Comp 3 is hard for NINCO and high grip tracks, Pro Comp 2 is the medium compound and Pro Comp is the soft for lower grip surfaces. Scaleauto also makes a grippy slipon rubber tire SC-4731 if you do not want to run sponge tires. We recommend you glue these tires to the rim for best results on NINCO and Carrera track.
Listing of useful parts for the 1/24 Scaleauto cars
Medium compound rubber rear tires SC-4737
Soft compound rubber rear tires SC-4736
Glued & trued sponge front tires on lightweight aluminum wheels SC-2715P these wheels can easily be fitted with the stock wheel inserts
Glued & trued sponge rear tires on lightweight sluminum wheels SC-2121p(supersoft), SC-2621p(soft), SC-2421p (medium), SC-2521P (hard) these wheels can easily be fitted with the stock wheel inserts
Guide spacer SC-1623 As stock on the 1/24 scale cars the guide is set for NINCO track with it's raised rails, if you will be running on Carrera or a routed wood track then you will find you need to shim the guide down to get fully in the slot. Or, and this is what we recommend, you can shift the guide from it's position atop the chassis plate to the bottom of the chassis plate, this is easily done as just four small screws hold the guide holder in place. If you choose to shift the guide carrier below the chassis plate then you will also want SC-1626 guide, this guide is a 'low profile' version of the stock guide.
|
